48
Chapter 2 The Menu Bar
3. Syslog Posting: Used in a UNIX operating system, it allows the PMU to
log alerts to a file located in the PMU installation directory. To log alerts,
check the Enable Syslog check box, then click Add (see Figure 32). A
task item adds to the log list. In the task item, specify the following as
applicable, then click Apply or OK.
Machine Address: The UNIX IP Address.
Port: See your system administrator.
Device: To choose a device item that you want the PMU to monitor,
such as a folder, specific printer, or a range of IP addresses.
First: To set the beginning IP address in a polling range. Use this
option if you select Range: as the Device option.
Last: To set the last IP address in a polling range. Use this option if
you select Range: as the Device option.
NOTE: In the remaining alert option fields, select enable or disable as
desired.
Offline, Warning, Media Input, Media Output, Media Path, Marker,
Cutter, Barcode, RFID, Scanner, Label, Intervention Needed,
Consumables, and Power Cart: For a description of the alert groups
and printer events, refer to “Alert Groups” in the SNMP Configuration
section of chapter three in the
Ethernet Interface User’s Manual
. All
options are enabled by default.
Comment: Enter comments as needed.
To Next Page
Loading...
Need help?
General
