Table 13. IMM2 error messages (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
v If an action step is preceded by “(Trained technician only),” that step must be performed only by a trained
technician.
806f010f-2201xxxx The System %1
encountered a POST
Hang. (%1 =
CIM_ComputerSystem.
ElementName)
Error The System
encountered a
firmware hang.
(Sensor =
Firmware Error)
1. Make sure the server meets the
minimum configuration to start
(see “Power-supply LEDs” on page
114).
2. Update the server firmware on the
primary page.
Important: Some cluster solutions
require specific code levels or
coordinated code updates. If the
device is part of a cluster solution,
verify that the latest level of code is
supported for the cluster solution
before you update the code.
3. (Trained technician only) Replace
the system board.
806f052b-2201xxxx IMM2 FW Failover
has been detected.
Error Invalid or
unsupported
firmware or
software was
detected.
1. Make sure the server meets the
minimum configuration to start
(see “Power-supply LEDs” on page
114).
2. Recover the server firmware from
the backup page:
a. Restart the server.
b. At the prompt, press F3 to
recover the firmware.
3. Update the server firmware to the
latest level (see “Updating the
firmware” on page 71).
Important: Some cluster solutions
require specific code levels or
coordinated code updates. If the
device is part of a cluster solution,
verify that the latest level of code is
supported for the cluster solution
before you update the code.
4. Remove components one at a time,
restarting the server each time, to
see if the problem goes away.
5. If the problem remains, (trained
technician) replace the system
board.
Web interface messages
40000001-00000000 IMM Network
Initialization
Complete.
Info An IMM network
has completed
initialization.
No action; information only.
Chapter 4. Troubleshooting 175
To Next Page
Loading...
Need help?
General