IBM System x3530 M4

Table 13. IMM2 error messages (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
v If an action step is preceded by “(Trained technician only),” that step must be performed only by a trained
technician.
40000017-00000000 ENET[0]
IP-Cfg:HstName=%1,
IP@%2, NetMsk=%3,
GW@=%4.(%1 =
CIM_DNSProtocolEndpoint.Hostname;
%2 =
CIM_StaticIPSettingData.IPv4Address;
%3 =
CIM_StaticIPSettingData.SubnetMask;
%4 =
CIM_StaticIPSettingData.DefaultGatewayAddress)
Info An IMM IP
address and
configuration have
been assigned
using client data.
No action; information only.
40000018-00000000 LAN: Ethernet[0]
interface is no longer
active.
Info The IMM Ethernet
interface has been
disabled.
No action; information only.
40000019-00000000 LAN: Ethernet[0]
interface is now
active.
Info The IMM Ethernet
interface has been
enabled.
No action; information only.
4000001a-00000000 DHCP setting
changed to [arg1] by
user [arg2].
Info The specified user
has changed the
DHCP setting of
the Integrated
Management
Module external
network interface.
No action; information only.
4000001b-00000000 Management
Controller [arg1]:
Configuration
restored from a file
by user [arg2].
Info The specified user
has restored the
Integrated
Management
Module (IMM)
configuration from
a previously saved
configuration file.
Some configuration
settings might
require that the
IMM be restarted
before they take
effect.
No action; information only.
180 System x3530 M4 Type 7160: Installation and Service Guide