Table 13. IMM2 error messages (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
v If an action step is preceded by “(Trained technician only),” that step must be performed only by a trained
technician.
40000025-00000000 The Chassis Event
Log (CEL) on system
%1 is 75% full.(%1 =
CIM_ComputerSystem.ElementName)
Info The IMM event log
is 75% full. When
the log is full,
older log entries
are replaced by
newer ones.
To avoid losing older log entries, save
the log as a text file and clear the log.
40000026-00000000 The Chassis Event
Log (CEL) on system
%1 is 100% full.(%1
=
CIM_ComputerSystem.ElementName)
Info The IMM event log
is full. When the
log is full, older
log entries are
replaced by newer
ones.
To avoid losing older log entries, save
the log as a text file and clear the log.
40000027-00000000 %1 Platform
Watchdog Timer
expired for %2.(%1 =
OS Watchdog or
Loader Watchdog;
%2 = OS Watchdog
or Loader Watchdog)
Error A Platform
Watchdog Timer
Expired event has
occurred.
1. Reconfigure the watchdog timer to a
higher value.
2. Make sure that the IMM Ethernet
over USB interface is enabled.
3. Reinstall the RNDIS or cdc_ether
device driver for the operating
system.
4. Disable the watchdog.
5. Check the integrity of the installed
operating system.
40000028-00000000 IMM Test Alert
Generated by %1.(%1
= user ID)
Info A user has
generated a test
alert from the
IMM.
No action; information only.
40000029-00000000 Security: Userid: '%1'
had %2 login failures
from an SSH client
at IP address %3.(%1
= user ID; %2 =
MaximumSuccessiveLoginFailures
(currently set to 5 in
the firmware); %3 =
IP address,
xxx.xxx.xxx.xxx)
Error A user has
exceeded the
maximum number
of unsuccessful
login attempts
from SSH and has
been prevented
from logging in for
the lockout period.
1. Make sure that the correct login ID
and password are being used.
2. Have the system administrator reset
the login ID or password.
40000030-00000000 IPv6 disabled by
user [arg1].
Info IPv6 protocol is
disabled by user.
No action; information only.
40000031-00000000 IPv6 static IP
configuration
enabled by user
[arg1].
Info IPv6 static address
assignment method
is enabled by user.
No action; information only.
40000032-00000000 IPv6 DHCP enabled
by user [arg1].
Info IPv6 DHCP
assignment method
is enabled by user.
No action; information only.
40000033-00000000 IPv6 stateless
auto-configuration
enabled by user
[arg1].
Info IPv6 stateless
auto-assignment
method is enabled
by user.
No action; information only.
184 System x3530 M4 Type 7160: Installation and Service Guide
To Next Page
Loading...
Need help?
General