To Next Page

To Previous Page

Table 14. DSA messages (continued)

v Follow the suggested actions in the order in which they are listed in the Action column until the problem is

solved.

v If an action step is preceded by “(Trained technician only),” that step must be performed only by a trained

technician.

v Go to the IBM support web site at http://www.ibm.com/supportportal/ to check for technical information,

hints, tips, and new device drivers or to submit a request for information.

Message

number Component Test State Description Action

405-901-xxx Ethernet

Device

Test MII

Registers

Failed

1. Make sure that the component firmware

is at the latest level. The installed

firmware level is shown in the DSA event

component. For more information, see

“Updating the firmware” on page 71.

2. Run the test again.

3. Replace the component that is causing the

error. If the error is caused by an adapter,

replace the adapter. Check the PCI

Information and Network Settings

information in the DSA event log to

determine the physical location of the

failing component.

4. If the failure remains, go to the IBM Web

site for more troubleshooting information

at http://www.ibm.com/systems/

support/supportsite.wss/

docdisplay?brandind=5000008

&lndocid=SERV-CALL.

405-902-xxx Ethernet