IBM System x3530 M4 User Manual

Table 14. DSA messages (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
v If an action step is preceded by “(Trained technician only),” that step must be performed only by a trained
technician.
v Go to the IBM support web site at http://www.ibm.com/supportportal/ to check for technical information,
hints, tips, and new device drivers or to submit a request for information.
Message
number Component Test State Description Action
405-903-xxx Ethernet
Device
Test
Internal
Memory
Failed
1. Make sure that the component firmware
is at the latest level. The installed
firmware level is shown in the DSA event
log in the Firmware/VPD section for this
component. For more information, see
“Updating the firmware” on page 71.
2. Run the test again.
3. Check the interrupt assignments in the
PCI Hardware section of the DSA event
log. If the Ethernet device is sharing
interrupts, if possible, use the Setup
utility see “Using the Setup utility” on
page 75) to assign a unique interrupt to
the device.
4. Replace the component that is causing the
error. If the error is caused by an adapter,
replace the adapter. Check the PCI
Information and Network Settings
information in the DSA event log to
determine the physical location of the
failing component.
5. If the failure remains, go to the IBM Web
site for more troubleshooting information
at http://www.ibm.com/systems/
support/supportsite.wss/
docdisplay?brandind=5000008
&lndocid=SERV-CALL.
238 System x3530 M4 Type 7160: Installation and Service Guide

IBM System x3530 M4 Specifications

General

Brand	IBM
Model	System x3530 M4
Category	Server
Language	English