Table 44. Resolving errors (continued)
Problem Solution
Can’t connect to Key
Management Server for LME.
• Run the Encryption Connectivity Check or Key Path Diagnostics and review
the results message. See “Locating Management functions” on page 79.
• Validate that the server conguration properties le includes support for TLS
1.2. See the encryption server documentation.
• If SKLM v2.7 or higher is used and you’re using the Library Self-Signed
Certicate. For one time only, you might need to reset your encryption
settings to clear out old versions of the self-signed certicate, recongure
encryption, then accept the new self-signed certicate on the encryption
server. See “Conguring Library Managed Encryption” on page 88.
• Check that your certicate algorithm is supported by your version of the
server.
Host application reporting
SCSI timeout
Note:
• The tape drive must rewind the tape before it is ejected. The amount of
time for this procedure can vary, depending on how the tape was used. See
“Supported tape drives” on page 10.
• The tape drive performs media optimization on the rst load of a cartridge.
The amount of time for this procedure can vary. See “Supported tape drives”
on page 10.
The procedure for SCSI timeouts varies depending on whether timeout is
consistent or intermittent, and on your drive conguration. Follow these steps
to troubleshoot a SCSI timeout:
1. Stop all Host Activity.
2. Check drive status by using any of the following methods:
• SCD display
• ITDT
• Indicator lights on a library if the drive is installed in a library
3. If the drive is in the middle of performing an operation, wait until the drive
is idle before attempting any further steps.
4. Validate that the drive has the latest rmware.
5. Check with software application provider for any updates.
6. Check whether the tape drive power is on.
7. Power down the drive.
8. Verify that the SAS or FC cable is connected properly to the server and to
the tape drive.
9. Replace SAS or FC cable if it shows any signs of damage.
10. Power on the drive and wait until the tape drive is idle or ready.
Pre-call checklist
If you have questions or problems with the library, complete these steps before a call to IBM technical
suppor
t is placed.
Note: Where instructions refer you to the web, go to http://www.ibm.com/storage/support/lto
.
1.
If you suspect the tape drive needs to be replaced, rst go to the section called READ and FOLLOW
before replacing drives
IBM Condential
110IBM TS4300 Tape Library Machine Type 3555: User's Guide
To Next Page
Loading...
Need help?
General
