IBM TS4300

Figure 47. Two modules in rack, seen from the rear
1 Locked
2 Unlocked
4. From the front of the library, tighten the Philips screws on each of the modules to secure the modules
to the rack.
5. From the back of the library, connect the modules of each pair to its adjacent module by using the
expansion interconnect cables (1) as shown in Figure 48 on page 63.
Note: The top module's top connector and the bottom module's bottom connector has nothing
plugged into them.
Figure 48. Connected modules
Installing a tape drive
Tape drives come already installed in the library modules.
Remember:
• Half-height tape drives can be installed in any drive bay in a module.
IBM Condential
Chapter 3. Installing63