Table 52. Pinch hazard
CAUTION: Risk of pinching hands or îš´ngers. Can trap hands,
îš´ngers, and cause serious injury. Keep hands clear during
operation. (L012)
Warning: Only individuals who are informed about the procedures and risks can replace or
upgrade this tape drive assembly. Read all troubleshooting documentation and procedures before
you proceed with repair or upgrade procedures. Hazardous moving parts exist inside this product.
Do not insert tools or any portion of your body into the drive bay openings.
Important: ESD events occurring during tape drive installation or removal may cause SAS link reset on
tape drives installed in the library. If this occurs, restart any jobs that were running on affected SAS links.
Before you begin
Read the topic, READ and FOLLOW before replacing drives. before doing and of the procedures on this
page.
Adding a tape drive
Remember:
• Half-height tape drives can be installed in any drive bay in a module.
• Full-height tape drives must be installed in the lowest two bays of a module. Installing a full-height drive
in the top two bays of a module is not supported.
1. If you are adding a tape drive, remove a drive bay cover. With a Philips screwdriver, remove one
half-height drive bay cover to install one half-height drive, or remove two drive bays covers to install a
full-height tape drive.
IBM Conîš´dential
Chapter 6. Upgrading and servicing151
To Next Page
Need help?
General
