IBM x3100 M5 Type 5457

4. Place the bottom edge of the housing into the bottom of the opening in the
chassis; then, tilt the top of the housing into position until it clicks into place.
5. Carefully turn the server on its side so that it is lying flat, with the cover
facing up.
Attention: Do not allow the server to fall over.
6. Reroute and connect the front USB cable to the front USB connector on the
system board (see “System-board internal connectors” on page 30 for the
location of the front USB connector).
Spring clips
Front USB connector
assembly
Front USB housing
Figure 170. Front USB connector assembly installation for 5U server model with hot-swap
power supplies (1)
Front USB housing
Figure 171. Front USB connector assembly installation for 5U server model with hot-swap
power supplies (2)
256 System x3100 M5 Type 5457: Installation and Service Guide