8-4
8
SCAN OPERATION
■ Scanning between programmed channels (VFO mode)
A programmed scan searches for signals between
scan edge memory channels P1 and P2.
The default frequencies for these memories are
0.500000 MHz and 29.99999 MHz.
See page 8-3 for scan edges programming.
Push q
V/M
➔
to select the VFO mode.
Push w
MODE
to select the desired operating
mode.
• The operating mode can be changed while scanning.
Push e
TS
to select a tuning step.
• The tuning step cannot be changed while scanning.
( The programmed tuning function can be turned ON or
OFF while scanning.)
Set the r [RF/SQL] control open or closed.
• See the page 8-2 for squelch status details.
Push t
SCAN
to start the scan.
• “ ” appears while scanning.
When the scan detects a signal, the scan either y
ignores it, pauses or the scan stops, depending on
the resume setting and the squelch status.
To cancel the scan, push u
SCAN
.
NOTE:
If the same frequencies are programmed
into both scan edge memory channels P1 and P2,
the programmed scan cannot start.
To Next Page
Loading...
