8-5
8
SCAN OPERATION
■ Scanning Memory channels (Memory mode)
A Memory scan searches for signals through memory
channels 1 to 199. Blank (unprogrammed) memory
channels are skipped.
Push q
V/M
➔
to select the Memory mode.
Close the squelch with the w [RF/SQL] control.
Push e
SCAN
to start the scan.
• “ ” appears while scanning.
When the scan detects a signal, the scan either r
stops or pauses, depending on the resume set-
ting.
To cancel the scan, push t
SCAN
.
• Rotating [DIAL] during scan also cancels the scan.
NOTE:
Two or more different memory channels
must be programmed for a memory scan to start.
To Next Page
Loading...
