Why does my IDEAL INDUSTRIES LANTEK show one or more open pins?
If your IDEAL INDUSTRIES Cable Tester shows one or more open pins, the connector-to-wire punch down might not be properly mated, the jack or plug could be defective, or the wire(s) may be broken. Check these components to resolve the issue.
General| Manufacturer | IDEAL INDUSTRIES |
|---|---|
| Model | LANTEK |
| Category | Cable Tester |
| Power Source | Rechargeable battery |
| Supported Standards | ISO/IEC 11801 |
| Display | LCD |
| Connectivity | USB |
| Features | Wire Map |
| Cable Types | Twisted pair, coax |
Summarizes procedures for initial setup and operation.
Overview of the LANTEK cable tester's capabilities and design.
Step-by-step guide for performing field calibration.
Covers various tester settings and preferences.
Procedure for selecting and changing cable types.
How to create and configure custom cable settings.
Explains the Autotest function and its benefits.
How to configure Autotest settings and options.
Step-by-step guide for performing an Autotest.
Guidance on understanding Autotest results and symbols.
Overview of troubleshooting by running individual tests.
Procedure for performing a single Analyze test.
Steps for installing and starting the LANTEK Reporter program.
Instructions for connecting the tester to a PC via USB or serial.
Procedure for transferring test data from the tester to the PC.
Steps for generating and printing test reports.
Purpose and procedure of the wire map test.
Tests for crosstalk at near and far ends of the cable.
Important safety instructions for handling NiMH battery packs.
To Next Page