Chapter 3
Calibration, Configuration, and Special Operations
3-35
4. Position the cursor over the
desired cable type and select
. The Custom Cable
screen appears.
5. Change the desired cable
settings, then proceed to the
next step, naming the cable.
6. Position the cursor over
Custom Name/NVP and press
Enter. The NVP Screen
appears.
7. Change NVP parameters as
required and then name your
new custom cable.
8. Press Enter to accept the
changes and return to the
Custom Cable screen.
The new custom cable is now
selected as the cable under test.
To Next Page
Loading...
Need help?
General