Chapter 3
Calibration, Configuration, and Special Operations
3-45
How to Perform a TDR Test
Prior to running the TDR, connect the LANTEK DH to the cable or link to be
tested.
Test Setup
1. Select the Cable Type (Refer to Chapter 3, Changing a Cable Type)
Note: All TDR numerical information is derived from the data in the cable database.
2. Calibrate and configure the tester as required (Refer to Chapter 3, Calibration
and Configuration sections).
Note: The tester retains the last configuration settings. Configuration settings must be
adjusted if one or more settings have changed.
3. Disconnect the cable to be tested from all network equipment.
4. Connect the required test lead to the Display Handset and to one end of the
link (TDR does not require a Remote Handset). Refer to Figures 7-3 and 7-4,
for Permanent and Channel Link connections.
5. Press to power up the Display Handset
To Next Page
Loading...
Need help?
General