Installation, Support, and Maintenance Guide 5
Evolution X1 Satellite Router
Electrical Safety
brand. Főr att undvika detta skall vid anslutning av utrustningen till kabel-TV nät
galvanisk isolator finnas mellan utrustningen och kabel-TV nätet.
2.2 Electrical Safety
Follow the warnings and cautions in Table 2-2 for personal safety and to protect the
equipment from electrical hazards.
Follow the following basic guidelines when working with any electrical equipment:
• Disconnect all power and external cables before installing or removing the chassis
• Do not work alone when potentially hazardous conditions exist
• Never assume that power has been disconnected; always check
• Do not perform any action that creates a potential hazard to people or makes the
equipment unsafe. Never install equipment that appears damaged
• Carefully examine the work area for possible hazards, such as wet floor, ungrounded
power extension cables, and missing safety grounds
Table 2-1. General Safety Warnings and Cautions
WARNING: Before working on the ODU equipment, unplug the power cord from
the power source.
CAUTION: Only Trained and qualified personnel should be allowed to install or
replace this equipment.
CAUTION: This equipment is to be installed and maintained by service personnel
only as defined by AS/NZS 3260 Clause 1.2.14.4 Service Personnel.
CAUTION: Do not remove the enclosure. Do not touch internal circuitry when the
power cord is connected.
CAUTION: The BUC power requirement must match the proper voltage. The BUC
may sustain damage if used with the incorrect power supply.
Table 2-2. Electrical Safety Warnings and Cautions
WARNING: Do not work on the system, or connect or disconnect cables, during
periods of lightning activity.
CAUTION: The BUC power requirement must match the proper voltage. The BUC
may sustain damage if used with the incorrect power supply.
To Next Page
Loading...
