iDirect X1 - RF Specifications; Table 3-3. X1 Router (Indoor) RF Specifications

Installation, Support, and Maintenance Guide 11
Evolution X1 Satellite Router
X1 Router (Indoor) Specifications
3.1.3 RF Specifications
Table 3-3 defines the X1 Router (Indoor) RF specifications.
Protection Internal, primary current fuse, inside power supply
Over current protection
Short circuit protection
Power Factor Correction Option 1 (only): Complies with EN61000-3-2 and EN61000-3-3
Input Transient Response 0.5 ms for 50% Load Change (TYP)
Power Supply Input Power
Connector
Option 1: IEC-320-C6
Option 2: Phoenix 1757488
Power Cord Option 1: 18 AWG, country dependent
Option 2: 14-18 AWG
Efficiency 87% (MIN)
Table 3-3. X1 Router (Indoor) RF Specifications
Category Description
Frequency Range
Transmit
Receive
950-1700 MHz
950-2150 MHz
Frequency Tuning Step Size
Transmit
Receive
0.6 Hz
Sub-Hertz with Demodulator
RF Power Range
Transmit
Receive
-30 dBm to 0 dBm
Single Carrier Input Power:
Minimum: -130 +10Log(Symbol Rate) dBm to - 5 dBm
Pmax = 0 dBm (MIN), 30 dB attenuation adjustable in 1 dB steps
Composite Wideband Input Power: -5 dBm (MAX)
RF Power Adjustability
Transmit
Receive
1.0 dB Nominal Step Size
Under AGC for all valid Rx input power range
Table 3-2. X1 Router (Indoor) Power Specifications (continued)
Category Description