Installation, Support, and Maintenance Guide 57
Evolution X1 Satellite Router
Appendix A Tools Needed
This section describes tools needed for X1 Router installation.
A.1 Indoor Coax Installation Tools Needed
Table A-1 specifies recommended tools and supplies for a typical indoor installation and
Figure A-1 on page 58 shows the tools.
NOTE: The tools intended for use in this section are intended to be generic.
Equipment should be installed per manufacturer’s requirements specific to the
brands preferred.
Table A-1. Recommended Installation Tools and Equipment for Indoor Coax
Quantity Tool
1 Number 2 Phillips screwdriver Figure A-1
1 F-Connector crimper or Compression Tool Figure A-1
1 RG-6 Coax Stripper, see Figure A-1
1 Coax / Wire Cutter, see Figure A-1
length as
needed
RG-6 or RG-11 solid copper conductor coax outdoor rated cable
To Next Page
Loading...
