Inateck BCST-33 - 1.4.1. Auto laser-off Mode

14
(*) Auto Laser-o󱐯 Mode
1s
3s
Setup Auto laser-o󱐯 waiting time
（*）2s
1.4. Scanning modes
Four kinds of scanning modes are supported by the Inateck BCST-33 Barcode
Scanner:
1.4.1. Auto laser-o󱐯 Mode
By default, the scanning mode is set to Auto laser-o󱐯 Mode. If the user click the Scan
Trigger, the Inateck BCST-33 Scanner will emit a red light line. This indicates the
scanner could scan barcode. If the barcode is not successfully scanned, the laser
will be o󱐯 automatically after auto laser-o󱐯 waiting time, which usually defaults to
2 seconds and can be setup to 1s, 2s, 3s and 5s. Yet the laser will be o󱐯 as soon as
Inateck BCST-33 scans barcode. E.g.: To set the scanning mode to Auto laser-o󱐯 mode
5s
and set the auto laser-o󱐯 waiting time to 1s, you need to:
1. Read the "Enter Setup" barcode;
2. Read the " Auto laser-o󱐯 Mode” barcode;
3. Read the”Setup Auto laser-o󱐯 waiting time” barcode; 4. Read the “1s” barcode;
5. Read the “Exit with Save” barcode.
15s