Inateck BCST-33 - 3.5. Code 93; 3.5.1. Enable;Disable Code 93

35
3.5. Code 93
3.5.1. Enable/ Disable Code 93
Decide whether to read Code 93 by scanning correspondent barcode below. Inateck
BCST-33 defaults Enable Code 93.
Note: Read the "Disable Code 93" barcode will make the scanner not able to read the
Code 93 barcode. Thus, if the scanner cannot read the Code 93 barcode, please try to
read "Enable Code 93" to reset.
Operations are as below if you want to enable Code 93:
1. Read the "Enter Setup" barcode;
2. Read the "Enable Code 93" barcode;
3. Read the "Exit with Save" barcode.
Enter Setup
(*)Enable Code 93
Exit with Save
Disable Code 93
Exit without Save