Inateck BCST-33 - 3.14. Standard 2 of 5; Industrial 2 of 5; 3.14.1. Enable; Disable Standard 25; 3.14.2. Checksum Verification

48
3.13. Matrix 2 of 5
3.13.1. Enable or Disable Matrix 25
Decide whether to enable Matrix 25 by scanning correspondent barcode below.
Inateck BCST-33 defaults to “Disable Matrix 25”.
3.13.2. Checksum Verication
Checksum character is not enforced to be included in the Matrix 25 data. If checksum
character is included, it should be the last character of the barcode data. As a
calculate value bases on all the data, Checksum character is used to check if the data
is correct or not.
Thus, if the scanner is set to "Do Not Verify”, which is default, then the scanner will
read and output all the barcode data.
If the scanner is set to "Verify with Output Checksum Character", and the scanner will
check the data based on the last characters of the barcode data. If the check passes,
the scanner will read and output the Checksum Character as the last character
of normal data; However, it will not be able to read Matrix 25 without checksum
character under this setting.
If the scanner is set to "Verify without Output Checksum Character", the scanner will
check the data based on the last characters of the barcode data but will not transmit
the checksum character. However, the scanner will be unable to read Matrix 25
barcode without Checksum character under this setting.
Enable Matrix 25
(*)Do Not Verify
Verify without Output Checksum
Character
(*)Disable Matrix 25
Verify with Output Checksum Character