Inateck BCST-33 - 3.10.4. Convert UPC-E to UPC-A; 3.10.5. Checksum Verification

44
3.10. UPC-E
3.10.1. Enable / Disable UPC-E
Decide whether to Enable UPC-E by scanning correspondent barcode below. Inateck
BCST-33 defaults “Enable UPC-E”.
3.10.2. Enable / Disable UPC-E 1
Decide whether to Enable UPC-E 1 by scanning correspondent barcode below.
Inateck BCST-33 defaults “Disable UPC-E 1”.
3.10.3. Start Character Transmission
Decide whether to include the Start character, which is limited to be “0”or “1”, in the
data being transmitted. Inateck BCST-33 defaults “Transmit UPC-E Start Characters”.
(*)Enable UPC-E
Enable UPC-E1
(*)Transmit UPC-E Start Character
Disable UPC-E
(*)Disable UPC-E1
Do Not Transmit UPC-E Start Character