Inateck BCST-33 - 3.1.2. Start;Stop Transmission

25
Enter Setup
(*)Transmit Codabar Start/Stop Characters
Exit with Save
Do not transmit Codabar Start/Stop
Characters
Exit without Save
3.1.2. Start/Stop Transmission
Decide whether to include Start/Stop characters in the data being transmitted by
scanning relevant barcodes below, with Transmit Codabar Start/Stop Characters as
default.
For example: Do Not Transmit Codabar Start/Stop Characters.
1. Read the "Enter Setup" barcode;
2. Read the "Enable Codabar" barcode; (If Codabar is disabled, it is needed to enable
it);
3. Read the "Do Not Transmit Codabar Start/Stop Characters" barcode;
4. Read the "Exit with Save" barcode.