Inateck BCST-33 - 3.4. Code 39; 3.4.1. Enable;Disable Code 39

29
3.3. Code 128
3.3.1. Enable / Disable Code 128
Decide whether to enable Code 128. Inateck BCST-33 Scanner defaults “Enable Code
128”.
Note: Read the "Disable Code 128" barcode will make the scanner unable to read
Code 128 barcode. Thus, if the scanner cannot read the Code 128 barcode, please try
to scan "Enable Code 128" to reset.
For Example: Steps to enable Code 128 are as below:
1. Read the "Enter Setup" barcode;
2. Read the "Enable Code 128" barcode;
3. Read the "Exit with Save" barcode.
Enter Setup
(*)Enable Code 128
Exit with Save
Disable Code 128
Exit without Save