Inateck BCST-33 - 3.10. UPC-E; 3.10.1. Enable; Disable UPC-E; 3.10.2. Enable; Disable UPC-E 1; 3.10.3. Start Character Transmission

43
3.9. UPC-A
3.9.1. Enable / Disable UPC-A
Decide whether to enable UPC-A barcode by scanning correspondent barcode
below. Inateck BCST-33 defaults “Enable UPC-A barcode”.
3.9.2. UPC-A output “0”
Decide whether to add "0" in the output of UPC-A data by scanning correspondent
barcode below. Inateck BCST-33 takes UPC-A Do Not output “0” as default.
3.9.3. Checksum Verication
Decide whether to Transmit UPC-A Checksum by scanning correspondent barcode
below. Inateck BCST-33 defaults “Transmit UPC-A Checksum”.
(*)Enable UPC-A
UPC-A Output “0”
(*)Transmit UPC-A Checksum
Disable UPC-A
(*)UPC-A Do Not Output “0”
Do Not Transmit UPC-A Checksum