15
Enter Setup
Exit with Save
Exit without Save
1.4.2. Continuous Scanning Mode
There’s no need to click Scan Trigger in this mode, as the laser of the scanner will
be on and the scanner will enter into scanning mode automatically. The laser
of the scanner will not go off until Inateck BCST-33 scans barcode. And the laser
will go off once the scanner scans barcode successfully. And then the scanner
will go into waiting mode, in which the waiting time(also known as intermittent
time of continuous scanning), usually defaults to 2 seconds, can be set to 400ms,
800ms,1s,2s,3s,5s, 10s and 15s. And the laser of the scanner will be on again once
the waiting time passes. And it will only goes o when the scanner scans barcode
successfully. And it will go back and forth like this.
Setup Intermittent Time of
Continuous Scanning
800ms
Continuous Scanning Mode
400ms
To Next Page
Loading...
