Inateck BCST-33 - 3.8. MSI; 3.8.1. Enable; Disable MSI barcode; 3.8.2. Checksum Verification

40
3.8. MSI
3.8.1. Enable / Disable MSI barcode
Decide whether to enable MSI barcode by scanning correspondent barcode below.
Inateck BCST-33 defaults “Disable MSI barcode”.
Note: Read the "Disable MSI" barcode will make the scanner unable to read the MSI
barcode. Thus, if the scanner cannot read the MSI barcode, please try to scan "Enable
MSI" barcode to reset.
Operations are as below if you want to enable MSI barcode:
1. Read the "Enter Setup" barcode;
2. Read the "Enable MSI" barcode;
3. Read the "Exit with Save" barcode.
Enter Setup
Enable MSI
Exit with Save
(*)Disable MSI
Exit without Save