Inateck BCST-33 - 3.4.2. Start;Stop Transmission

30
3.4. Code 39
3.4.1. Enable/Disable Code 39
Decide whether to enable Code 39. Inateck BCST-33 Scanner defaults “Enable Code
39”.
3.4.2. Start/Stop Transmission
Decide whether to include the Start/Stop characters in the data being transmitted
through selecting correspondent barcode below. Inateck BCST-33 takes disabling
transmitting Code39 Start/ Stop Characters as default.
For example: Steps to not transmit code 39 Start/Stop Characters are as below:
1. Read the "Enter Setup" barcode;
2. Read the "Enable Code 39" barcode; (If Code 39 is disabled, it is needed to enable
it);
3. Read the "Do Not Transmit Code 39 Start/Stop Characters" barcode;
4. Read the "Exit with Save" barcode.
(*)Enable Code 39
Transmit Code 39 Start/Stop Characters
Disable Code 39
(*)Do not Transmit Code 39 Start/Stop
Characters
Enter Setup
Exit with Save
Exit without Save