Inateck BCST-33 - Chapter 4 Defining Output Format; 4.1. Code ID

51
3.16. GS1-128
3.16.1. Enable/Disable GS1-128
3.16.2. FUNC1
The FUNC1 in GS1-128 is replaced with ‘I’ by default. The FUNC1 can also be replaced
by ASCII GS character (which is 29).
How to Enable GS1-128:
1. Read “Enter Setup”;
2. Read “Enable GS1-128”;
3. Read “Exit with Save”.
Enter Setup
(*)Enable GS1-128
Replace FUNC1 with ASCII “29”
Exit with Save
Disable GS1-128
(*)Replace FUNC1 with '|'
Exit without Save