Inateck P7 - Restore Factory Defaults; Check Software Version

11
Restore Factory Defaults
Scan the barcodes "Enter setup" and "Restore factory defaults" in sequence. The P7 will respond
with two short beeps (tone ascending from low to high) and three chord sounds after successful
setting. There is no need to scan the "Exit with save" barcode in this case.
Restore Factory Default
Note: Most of the settings have factory default value. The default value for each setting is marked
by an asterisk "*". After restoring to the factory default, the P7 will switch to 433MHz wireless
mode.
“Restore Factory Defaults” barcode can be used under following circumstances:
1. The scanner doesn’t work. For example, it cannot read/ scan any barcodes.
2. You forget what settings you ever make on the scanner, while you don't want to be disturbed
by the forgotten settings when you use the barcode scanner.
3. You are going to use a function that is not frequently used, or you have finished using such a
function.
Check Software Version
If you want to check the software version of Inateck P7, you should scan the “Enter Setup” and
“Output Software Version” barcode, then you will get it on the device connected with the P7.
Enter setup
Output Software Version
“Check Software Version” is done in the enter setup mode, so please scan “Exit without Save”
barcode after the software version outputs.
Exit without Save