14
（*）Disable Clear Data in Buffer When
the scanner was turned on
When the connection is completed, it is necessary to double click the trigger if you want to
upload the data to computer as the data in the buffer won’t be uploaded automatically. You can
also set whether to upload the data automatically by scanning the following barcodes. The
default is “Disable Auto Uploading Buffer Data”.
If you want to upload the data in buffer automatically after successful connection, please set
“Enable Auto Uploading Buffer Data”.
Enable Auto Uploading Buffer Data
（*）Disable Auto Uploading Buffer Data
Enter setup
Exit with save
If you want to keep the scanned result in the buffer of the barcode scanner, you can choose
inventory mode. In inventory mode, Inateck P7 will count the number of the barcodes
automatically. Users may use inventory mode to keep scanned barcodes in the buffer of Inateck
P7, and upload them to computer in batches. Under inventory mode, users are not restricted to
the time and location when upload data. Of course, history data can be cleared in buffer after
uploading. More details about inventory mode are as below.
1) Scan the “Enter Inventory Mode” barcode to enter Inventory Mode
Enter Inventory Mode
To Next Page
Loading...
