35
（*）Disable Code 11
Note: Read the "Disable Code 11" barcode will make the scanner not being able to read the Code
11 barcode. Thus, if the scanner cannot read the Code 11 barcode, please try to scan "Enable
Code 11" to reset.
For example: Enable Code 11.
1. Read the "Enter Setup" barcode;
2. Read the "Enable Code 11" barcode;
3. Read the "Exit with Save" barcode.
Enter setup
Exit with save
Exit without save
3.2.2 Checksum Verification
Checksum character is not enforced to be included in the data of Code 11. If checksum character
is included, it should be the last one or two characters of the barcode data. As a calculate value
based on all the data, Checksum character is used to check whether the data is correct or not.
If the scanner is set to "Do Not Verify code”, which is default, the scanner will read all the
barcode data.
If the scanner is set to "Verify with one digit Checksum Character", the scanner will check the
data based on the last character of the barcode data. It will not be able to read code 11 without
checksum character or code 11 with two digits checksum character.
If the scanner is set to "Verify with two digits Checksum Character", the scanner will check the
data based on the last two characters of the barcode data. It will not be able to read code 11
without checksum character or code 11 with one digit checksum character.
To Next Page
Loading...
