Inateck P7 - Upc-E; Enable;Disable UPC-E; Enable;Disable UPC-E1

51
Enter setup
Exit with save
3.10 UPC-E
3.10.1 Enable/Disable UPC-E
Decide whether to Enable UPC-E by scanning correspondent barcode below. Inateck P7 defaults
“Enable UPC-E” .
（*）Enable UPC-E
Disable UPC-E
3.10.2 Enable/Disable UPC-E1
Most of the start character of UPC-E is 0. If you want to read the barcode with the start character
“1”, please set the scanner to enable UPC-E, then set to enable UPC-E1. Inateck P7 defaults
“Disable UPC-E 1”.
Enable UPC-E1
（*）Disable UPC-E1