Inateck P7 - Msi; Enable;Disable MSI

47
Operations are as below if you want to convert EAN-13 to ISSN:
1. Read the "Enter Setup" barcode;
2. Read the "Convert EAN-13 to ISSN" barcode;
4. Read the "Exit with Save" barcode.
Enter setup
Exit with save
Exit without save
3.8 MSI
3.8.1 Enable/Disable MSI
Decide whether to enable MSI barcode by scanning correspondent barcode below. Inateck P7
defaults “Disable MSI barcode”.
Enable MSI
（*）Disable MSI
Note: Read the "Disable MSI" barcode will make the scanner unable to read the MSI barcode.
Thus, if the scanner cannot read the MSI barcode, please try to scan "Enable MSI" barcode to
reset.
Operations are as below if you want to enable MSI barcode:
1. Read the "Enter Setup" barcode;
2. Read the "Enable MSI" barcode;
3. Read the "Exit with Save" barcode.
Enter setup