Inateck P7 - Start Character Transmission; Convert UPC-E to UPC-A; Checksum Verification

52
3.10.3 Start Character Transmission
Decide whether to include the Start character, which is limited to be “0”or “1”, in the data being
transmitted. Inateck P7 defaults “Transmit UPC-E Start Characters”.
（*）Transmit UPC-E Start Characters
Do Not Transmit UPC-E Start Character
3.10.4 Convert UPC-E to UPC-A
Decide whether to convert the UPC-E to UPC-A by scanning correspondent barcode below.
Inateck P7 defaults “Do Not Convert UPC-E to UPC-A”.
Convert UPC-E to UPC-A
（*）Do Not Convert UPC-E to UPC-A
3.10.5 Checksum Verification
Decide whether to transmit UPC-E Checksum by scanning correspondent barcode below. Inateck
P7 defaults “Transmit UPC-E Checksum”.
（*）Transmit UPC-E Checksum
Do Not Transmit UPC-E Checksum