Inateck P7 - Chapter 2 How to Connect; 2.1 433 MHz Wireless Mode

25
Chapter 2 How to Connect
2.1 433MHz Wireless Mode
433MHz wireless mode is the default connection mode of P7 barcode scanner. If you
are using other connection modes and want to switch it back to the 433MHz wireless
mode, please scan the setting barcodes in sequence "Enter Setup" - "433MHz
Wireless Mode" - "Exit with Save".
（*）433MHz Wireless Mode
Enter setup
Exit with save
Under this mode, you need to plug the receiver into the USB port of a computer. When the USB is
configured successfully, the indicator light on the receiver will flash once and then go off. Open a
new text on your computer, move the cursor to the blank area on the text, the scanned data will
be transmitted to the text file.
2.1.1 433MHz Wireless Pairing
The P7 has been paired with its receiver before leaving the factory. If you replace the receiver,
please re-pair it with the P7. The pairing method is flexible, which allows you to pair one or more
P7 scanners with one receiver, also you can pair one scanner with multiple receivers (up to 8
receivers can be paired).
Steps to Pair one scanner with one USB adapter:
a. Plug the adapter into your computer.
b. Scan “Enter Setup” barcode.
c. Scan the barcode "Pair one or more scanners with one USB adapter", and get the Inateck P7
as close as possible to the USB adapter (within 2 meters).
d. A three-chord sound (from low to high) indicates a successful pairing. Once there is a long
high tone, it means the pairing fails and a repeated operation is needed.