26
Pair one or more scanners with one USB adapter
To pair more scanners with the adapter, please operate as the steps mentioned above.
Steps to pair one scanner with multiple USB adapters
a. Unplug the previous USB adapter.
b. Scan “Enter Setup” barcode.
c. Scan the barcode “Pair one scanner with multiple USB adapters”, and get the Inateck P7 as
close as possible to the USB adapter (within 2 meters).
d. Insert the USB adapter into a computer. The indicator of the adapter flashes along with a
short high tone, which indicates a successful pairing.
e. Unplug the adapter (no operation is required on the barcode scanner in this process), and
then plug the second adapter into the computer, a short high tone indicates another
successful pairing. Then repeat this process to pair the next adapter.
f. If all the adapters have been paired with the P7 barcode scanner, please short press the
trigger on the barcode scanner, and the pairing stops.
Note: The more USB adapters a P7 barcode scanner is connected with, the longer transmission
time it takes and the longer time you need to wait after scanning.
Pair one scanner with multiple USB adapters
Enter setup
Exit with save
To Next Page
Loading...
