Inateck P7 - 1.5 Vibration Notification; Vibration Notification Settings

17
For example: Steps to set Minimum Volume for beeper are as below:
1. Read the "Enter Setup" barcode;
2. Read the "Minimum Volume" barcode;
3. Read the "Exit with Save" barcode.
Note: The factory default value for each setting is marked by an asterisk "*".
Enter setup
Exit with save
Exit without save
1.5 Vibration Notification
The P7 barcode scanner is featured with vibration notification which is turned on by default, to
indicate successful scanning. You can enable/disable this function and adjust the vibration
strength.
Turn off the vibration notification
（*）Turn on the vibration notification (weak)
Turn on the vibration notification (strong)
The steps to turn off the vibration notification are as follows:
1） Read “Enter setup” barcode.
2） Read “Turn off the vibration notification” barcode.
3） Read “Enter with save” barcode.
Enter setup