Inateck P7 - Page 36

36
If the scanner is set to "Verify with Output Checksum Character", the scanner will check the data
based on the last one or two characters of the barcode data. Inateck P7 default outputs
checksum characters.
If the scanner is set to "Verify without Output Checksum Character", the scanner will not output
checksum character.
（*）Do Not Verify code
Verify with one digit Checksum Character
Verify with two digits Checksum Character
（*）Verify with Output Checksum Character
Verify without Output Checksum Character
For example, Operations are as below if you want to set Verify with one-digit Output Checksum
Character but without Output Checksum Character.:
1). Scan the “Enter Setup” barcode；
2). Read the "Verify with one digit Output Checksum Character" barcode;
3). Read the "Verify without Output Checksum Character" barcode；
4) Read the "Exit with Save" barcode.
Enter setup
Exit with save