Inateck P7 - Page 30

30
After the successful connection, you can scan the barcodes which will be displayed on the
serial debugging tool as follows:
To disconnect the Bluetooth, just close the serial debugging tool.
To use the Bluetooth SPP mode of P7 on another computer, there is no more operation needed
for P7, just disconnect the P7 on the previous connected computer, and then the P7 will enter
Bluetooth broadcasting mode. Search P7 and pair it on another computer. After successful
pairing, you need to run serial debugging tool on the new computer and follow the steps to Open
Bluetooth COM Port as mentioned above.