Inficon Ecotec E3000 User Manual

INFICON Operation | 6
Ecotec E3000-Operating-instructions-kina22en1-28-(2211) 35 / 104
Alarm profile Pinpoint Alarm profile Setpoint Alarm profile Trigger /
Alarm
Search value exceeded - Acoustic signal low
frequency
Acoustic signal low
frequency
Trigger value exceeded - Acoustic signal high
frequency
Two-tone signal
Acoustic tracing of the
measurement result
<1/10 Trigger value: Low
frequency
- -
>1/10 value of trigger to
10 x value of trigger:
Rising frequency
> 10 x value of trigger:
High frequency
Comment Recommended, for
precise leak localization
- Recommended, for
precise leak localization
This allows identification
with a signal for devices
that are used together.
Table3: Features of the alarm profiles
Volume You can adjust the volume that cannot be set lower with the plus and minus buttons
next to the display. This way you can prevent the acoustic signals from being switched
off accidentally during the measurement.
The adjustment applies to the speaker in the basic unit and the head phones. You can
also set the current volume of speaker and head phones here.
Setting range: 0 to 15
WARNING
Hearing damage from excessively loud signal tones
The volume of the signal tones can exceed 85dB(A)
► Keep away from the device when setting high volumes.
► Wear ear protection when necessary.
6.3.3 Display settings
In the menu “Settings > Display”, you can set the display details of the device display
and the display in the sniffer handle.
Contrast Increase or reduce the contrast of the display using the arrow keys. If you press and
hold the buttons, the values change continuously. The setting is applied immediately
to the display.
• To adjust the contrast of the currently displayed menu, select “Automatic”.

Inficon Ecotec E3000 Specifications

General

Brand	Inficon
Model	Ecotec E3000
Category	Security Sensors
Language	English