INFICON Installation | 5
Ecotec E3000-Operating-instructions-kina22en1-28-(2211) 19 / 104
5 Installation
5.1 Setup
DANGER
Danger from moisture and electricity
Moisture entering the device can lead to personal injury due to electric shocks as well
as damage to property due to short circuiting.
► Operate the Ecotec E3000 only in a dry environment.
► Operate the Ecotec E3000 away from sources of liquid and moisture.
CAUTION
Danger due to dropping heavy loads
The device is heavy and can damage persons and items through tilting or dropping.
► Place the device only on a sufficiently sturdy surface.
NOTICE
Property damage due to vibration
Parts of the measurement technology rotate and must not be shaken. The parts
continue to rotate for several minutes after the device is shut down.
► Place the device only on a sturdy, vibration-free surface.
► The device must not be shaken during operation and at least five minutes after
being switched off.
NOTICE
Property damage due to overheated device
The device heats up during operation and can overheat without sufficient ventilation.
► Observe the permissible operating or ambient temperature.
► Ensure adequate ventilation. There must be 20 cm of free space on the upper side
of the device above the ventilation opening.
► The ventilation opening on the underside of the device must remain unobstructed.
► Keep heat sources away from the device.
► Do not expose the device to direct sunlight.
To Next Page
Loading...
Need help?
General
