Inficon Ecotec E3000 User Manual

2 | Safety INFICON
8 / 104 Ecotec E3000-Operating-instructions-kina22en1-28-(2211)
• Personnel to be trained must only work with and on the device under the
supervision of trained, specialist technical personnel.
• Make sure that authorized personnel have read and understood the operating
instructions and all other applicable documents, see "Other associated documents
[}6]," especially the information on safety, maintenance and repairs, before
starting work.
• Regulate the responsibilities, authorizations and supervision of personnel.
2.3 Operator requirements
• Read, observe and follow the information in these operating instructions and the
working instructions created by the owner, especially the safety instructions and
warnings.
• Carry out any work only based on the complete operating instructions.
• If you have any questions regarding operating or maintenance that is not
explained in this manual, then please contact INFICON customer services.
2.4 Dangers
The measuring instrument was built according to the state-of-the-art and the
recognized safety regulations. Nevertheless, improper use may result in risk to life and
limb on the part of the user or third parties, or damage to the instrument or other
property may occur.
Danger due to use in
EX/ATEX areas
If the workplace is classified as a hazardous area according to Ex/ATEX regulations it
is mandatory to apply Ex/ATEX certified equipment.
Ecotec E3000 including INFICON sniffer lines are not EX/ATEX certified.
In risk-free areas and non-classified environments Ecotec E3000 can be safely used.
The major risk associated with the leak detector is always the atmosphere around and
inside the instrument enclosure and not the gas aspired by the sniffer into the interior
of the detector.
Dangers from electric
power
The device is operated with electrical voltages of up to 236V. Touching parts where
electrical voltage is present can result in death.
► Disconnect the device from the power supply prior to any installation and
maintenance work. Ensure that the electrical supply cannot be switched back on
unintentionally.
Touching live parts with the sniffer tip can result in death.
► Before starting the leak test, disconnect electrically operated test objects from the
power supply. Ensure that the electrical supply cannot be switched back on
unintentionally.
The device contains electric components that can be damaged from high electric
voltage.

Inficon Ecotec E3000 Specifications

General

Brand	Inficon
Model	Ecotec E3000
Category	Security Sensors
Language	English