Ingenico Move 3500 User Manual

Page 43
Move/3500 User Guide
Copyright© 2017 Ingenico
Completion
If the final bill is more than 15% higher than the total ‘Pre-
Authorised’ amount, an additional ‘Pre-Authorisation’ transaction
will be required for the difference which must be obtained prior to
the carrying out of the ‘Completion’ transaction.
The following procedure will complete a ‘Pre-Authorised’ transaction when the
final amount is confirmed with the customer.
Completion Swipe Card
Press at the ‘Idle
Screen’. Highlight
‘Completion’ as
described earlier and
press .
Enter first pre-auth
code and press .
Enter the final amount
and press .
Press if the printout
is readable; else press
the
button to print the
merchant receipt again.
Swipe the cardholder’s
card. You may be
asked to key in the last
four digits of the
cardholder’s card
number.
Cardholder to sign the
receipt. Check if they
match, press if OK,
else press to
reverse transaction.

Ingenico Move 3500 Specifications

General

Battery	Li-ion 2200mAh
Security	PCI PTS 5.x certified
Processor	ARM Cortex A5
Connectivity	Wi-Fi, Bluetooth, 3G
Operating System	Telium TETRA
Card Readers	EMV chip, NFC, magnetic stripe
Weight	320g
Display	2.4-inch QVGA (240x320 pixels)