Ingenico Move 3500 User Manual

Page 45
Move/3500 User Guide
Copyright© 2017 Ingenico
Account Verification
Account Verification Swipe Card
Press at the ‘Idle
Screen’. Highlight
‘Verify Account’ as
described earlier and
press .
If the account is valid
this screen is shown.
Terminal will print the
cardholder receipt.
Swipe the customer’s
card.
Press if the printout
is readable; else press
to print the
cardholder receipt
again.
The terminal will check
the card
Press if the printout
is readable; else press
button to print the
merchant receipt again.
Terminal will connect to
the host.
NOTE: This is a ZERO value
transaction. No transaction amount is
required.
Terminal will receive a
response from the host.
Note: If the account is
not valid a screen
similar to the following
will be
displayed.

Ingenico Move 3500 Specifications

General

Battery	Li-ion 2200mAh
Security	PCI PTS 5.x certified
Processor	ARM Cortex A5
Connectivity	Wi-Fi, Bluetooth, 3G
Operating System	Telium TETRA
Card Readers	EMV chip, NFC, magnetic stripe
Weight	320g
Display	2.4-inch QVGA (240x320 pixels)