Ingenico Move 3500 User Manual

Page 46
Move/3500 User Guide
Copyright© 2017 Ingenico
Account Verification Insert Card
Press at the ‘Idle
Screen’. Highlight
‘Verify Account’ as
described earlier and
press .
If the account is valid
this screen is shown.
Terminal will print the
cardholder receipt.
Insert/Swipe the
customer’s card.
Press if the printout
is readable; else press
to print the
cardholder receipt
again.
The terminal will check
the card
Remove the card from
the terminal
Terminal will print the
merchant receipt.
Cardholder to enter the
PIN code and press .
Press if the printout
is readable; else press
to print the
cardholder receipt
again.
Terminal will connect to
the host.
Note: If the account is
not valid a screen
similar to the following
will be displayed.
NOTE: This is a ZERO value transaction.

Ingenico Move 3500 Specifications

General

Battery	Li-ion 2200mAh
Security	PCI PTS 5.x certified
Processor	ARM Cortex A5
Connectivity	Wi-Fi, Bluetooth, 3G
Operating System	Telium TETRA
Card Readers	EMV chip, NFC, magnetic stripe
Weight	320g
Display	2.4-inch QVGA (240x320 pixels)