Ingenico Move 3500 User Manual

Page 12
Move/3500 User Guide
Copyright© 2017 Ingenico
Battery
Main Characteristics
Operating Conditions
Characteristics Li-ion 2900 mAh
Charge
(power supply - 1.5A)
50% capacity in 1,5 h; full capacity in 4 hours
Installing the battery
Check that the terminal is not connected to the mains electricity
network
• Turn the terminal over and unclip the back cover by pushing on the clip
• Take the battery pack included in the box
• Locate the battery pack connector
beside the battery compartment
• Plug the battery pack into the
battery pack connector
• Verify that it locks
• Place the battery pack in its
compartment.
• Close the back cover
Battery connector
Battery compartment

Ingenico Move 3500 Specifications

General

Battery	Li-ion 2200mAh
Security	PCI PTS 5.x certified
Processor	ARM Cortex A5
Connectivity	Wi-Fi, Bluetooth, 3G
Operating System	Telium TETRA
Card Readers	EMV chip, NFC, magnetic stripe
Weight	320g
Display	2.4-inch QVGA (240x320 pixels)