Ingenico Move 3500 - Function 30 Set Date and Time

Page 70
Move/3500 User Guide
Copyright© 2017 Ingenico
Function 30 Set Date and Time
You may have been prompted to set the ‘Date and Time’ when installing your
terminal. However if you have a need to amend either of them this is achieved
as follows:
Press the button until the ‘System Menu’ is displayed and enter the Function
Code 30 as described in ‘Selecting Function Codes’ above.
Press if the date is
correct or type in the
correct date
(ddmmyyyy) and then
press .
Press if the time is
correct or type in the
correct time (hhmm)
and then press .