Ingenico Move 3500 User Manual

Page 63
Move/3500 User Guide
Copyright© 2017 Ingenico
Function Codes
There may be occasions when you have further requirements of your terminal.
These can be met through the use of Function Codes.
Function Codes other than the following should only be used on
the advice of the Helpdesk.
Selecting Function Codes
To access the ‘Function Codes Menu’ press the button until the ‘System
Menu’ is displayed:
Use or to
highlight ‘Select
Function’.
Type in the
‘Function Code’
required and then
press to select it.
Press to select
the highlighted
option.
This screen will
only be displayed
if a ‘Supervisor
Code’ is
required.

Ingenico Move 3500 Specifications

General

Battery	Li-ion 2200mAh
Security	PCI PTS 5.x certified
Processor	ARM Cortex A5
Connectivity	Wi-Fi, Bluetooth, 3G
Operating System	Telium TETRA
Card Readers	EMV chip, NFC, magnetic stripe
Weight	320g
Display	2.4-inch QVGA (240x320 pixels)