Ingenico Move 3500 - Function 40 Waiter Setup; Add Waiter

Page 66
Move/3500 User Guide
Copyright© 2017 Ingenico
Function 40 Waiter Setup
A ‘Default Waiter ID’ exists to capture the gratuity amount from each transaction
if ‘Gratuity’ is enabled on your terminal. However you may wish to set up
individual ‘Waiter IDs’ to record the amount of gratuity each waiter has accrued.
The ‘Waiter Menu’ will allow you to ‘Add, Delete, Print, Change Name, Delete All
or Create Defaults.
Press until the ‘System Menu’ is displayed and enter the Function Code 40
as described in ‘Selecting Function Codes’ above.
Add Waiter
Press to setup
waiters or press
or
to return to the ‘Idle
Prompt’.
Press when you
have typed in the
waiter’s name. The
details will be printed.
Use or to
highlight the required
option and then press
to select or to exit.
The details will be
printed before returning
to the ‘Waiter Setup
Menu’.
Start to type in the
‘Waiter’s Name’ as
described earlier in this
manual. The screen
will change to the
following:
Repeat for each waiter
to be added.
You may set up a
maximum of 99 waiter’s
names. Press
to exit
the menu.